Publications (20) Publications in which a researcher has participated

filter_list Mechanics of Materials

2023

  1. A novel fully removable walkway system with non-invasive anchors for structural health inspection and maintenance of historic steel structures

    Structures, Vol. 53, pp. 1435-1449

  2. Removable, Reconfigurable, and Sustainable Steel Structures: A State-of-the-Art Review of Clamp-Based Steel Connections

    Sustainability (Switzerland), Vol. 15, Núm. 10

2022

  1. Experimental Analysis of the Bending Behavior of Structural Metal Joints Based on the Use of Girder Clamps to Service Life Extension of Existing Structures

    RILEM Bookseries (Springer Science and Business Media B.V.), pp. 1-9

  2. The Centroid Method for the Calibration of a Sectorized Digital Twin of an Arch Dam

    Water (Switzerland), Vol. 14, Núm. 19

2021

  1. Analysis of stiffness of clamped joints versus bolted joints in steel structures by means of accelerometers and shaking table tests

    Sensors, Vol. 21, Núm. 14

  2. Analytical model for the fatigue analysis of steel joints by clamps according to the lever length

    Materials, Vol. 14, Núm. 24

2020

  1. A new approach to the consideration and analysis of critical factors in robotic machining

    Applied Sciences (Switzerland), Vol. 10, Núm. 24, pp. 1-18

  2. Optimization methodology for additive manufacturing of customized parts by fused deposition modeling (FDM). Application to a shoe heel

    Polymers, Vol. 12, Núm. 9

2015

  1. The mechanically contaminated layer theory of sand-filled fibreglass-reinforced polyester pipes: An explanation of the initial process for the mechanical and hydrolytical behaviour of massive pipeline failures

    Journal of Composite Materials, Vol. 49, Núm. 6, pp. 647-658

2010

  1. A numerical approach and comparison of cutting forces and chip morphology in orthogonal cutting of light alloys

    AIP Conference Proceedings

2009

  1. Cutting speed and feed based model for evaluating parallelism deviations in horizontal dry turning of aluminium alloys

    Annals of DAAAM and Proceedings of the International DAAAM Symposium

  2. Implementation of technological and geometrical parameters in forging processes by means of the upper bound element technique

    AIP Conference Proceedings

  3. Influence of the coating tool on the morphology of the chips obtained during the dry turning of UNS A97050-T7 aluminium alloys

    Annals of DAAAM and Proceedings of the International DAAAM Symposium

2008

  1. An empirical relationship between cutting forces and length in dry drilling in aluminium alloys

    Annals of DAAAM and Proceedings of the International DAAAM Symposium

  2. Evaluation of forces in indentation processes considering geometric parameters of the workpiece

    Annals of DAAAM and Proceedings of the International DAAAM Symposium

  3. Influence of cutting conditions and tool coatings on the surface finish of workpieces of magnesium obtained by dry turning

    Annals of DAAAM and Proceedings of the International DAAAM Symposium

  4. Influence of the geometry of the workpiece on contact pressures in frictionless indentation processes

    ESM 2008 - 2008 European Simulation and Modelling Conference: Modelling and Simulation 2008

2007

  1. Analysis of axisymmetrical compression processes by the finite element method

    AIP Conference Proceedings

2005

  1. Analysis of forces and contact pressure distributions in forging processes by the finite element method

    Annals of DAAAM and Proceedings of the International DAAAM Symposium

2003

  1. BUE and BUL Formation Mechanisms in Dry Cutting of AA7050 Alloy

    Annals of DAAAM for 2003 & Proceedings of the 14th International DAAAM Symposium