ANA MARIA
CAMACHO LOPEZ
Catedrático de Universidad
JUAN
CLAVER GIL
Profesor Contratado Doctor
Publicaciones en las que colabora con JUAN CLAVER GIL (13)
2024
2023
-
Determination of Suitable Geometrical Ranges for the Manufacture of Microfluidic Channels by Low-Cost Additive Manufacturing Techniques
Key Engineering Materials (Trans Tech Publications Ltd), pp. 3-11
-
Other dimensions of additive manufacturing: Learning and development of technical skills in bachelor subjects
Advances in Science and Technology
-
The Effect of Design and Fabrication Parameters on the Mechanical Properties of 3D Re-Entrant Honeycomb Auxetic Structures
Key Engineering Materials (Trans Tech Publications Ltd), pp. 131-138
-
The Potential of Education and Training in Additive Manufacturing
Mechanisms and Machine Science
2020
-
Analysis of General and Specific Standardization Developments in Additive Manufacturing from a Materials and Technological Approach
IEEE Access, Vol. 8, pp. 125056-125075
-
Considerations on the applicability of test methods for mechanical characterization of materials manufactured by FDM
Materials, Vol. 13, Núm. 1
2018
-
El mapeo de los TFT en la UNED
La profesionalización del docente a través de la innovación educativa. Libro de actas: IX Jornadas de redes de investigación en innovación docente. UNED, Madrid. 28, 29 y 30 de junio de 2017
-
The influence of manufacturing parameters on the mechanical behaviour of PLA and ABS pieces manufactured by FDM: A comparative analysis
Materials, Vol. 11, Núm. 8
2017
-
Incremental versus continuous load-lubrication procedure in the determination of friction conditions by the ring compression test
International Journal of Mechatronics and Manufacturing Systems, Vol. 10, Núm. 1, pp. 71-83
-
Valuation of strategies for the incorporation of 3d printing contents in the teaching of subjects linked to productive processes from different approaches
Materials Science Forum
2016
2015
-
Comparative analysis of extrusion processes by finite element analysis
Procedia Engineering